Describe the bug
It cycles through power state 3, then 6, then 12 and reboots.
This only happens when a tip is in place, if I try without a tip installed it stays at "State 3", and normal mode boots as it should.
To Reproduce
- Connect to MacBook Pro (M2 Max) PD
- Observe device negotiating then rebooting.
- Connect with (+) pressed, see "State 3" -> "State 6" -> "State 12", before reboot
Expected behavior
Whatever power is provided via USB PD properly negotiate it so the iron will use only supported ones. Ideally when power not sufficient to iron but sufficient for powering up it should display the limitation
Details of your device:
- Device: Pinecil V2
- Release: v2.22 stable, v2.23 stable, and the latest actions run
from dev as of 2026-08-24
- Power adapter being used: MacBook Pro (M2 Max) Thunderbolt 4 port
Describe the bug
It cycles through power state 3, then 6, then 12 and reboots.
This only happens when a tip is in place, if I try without a tip installed it stays at "State 3", and normal mode boots as it should.
To Reproduce
Expected behavior
Whatever power is provided via USB PD properly negotiate it so the iron will use only supported ones. Ideally when power not sufficient to iron but sufficient for powering up it should display the limitation
Details of your device:
from dev as of 2026-08-24